Application method of the hottest jaw crusher

  • Detail

How to use jaw crusher

I. preparations before starting:

1. Carefully check whether the lubrication of the bearing is good and whether there is enough grease at the elbow joint in the bearing

2. Carefully check whether all fasteners are completely fastened

3. Whether the protective device is good. Plastic tiles have the characteristics of cork floor. If unsafe phenomena are found, they should be eliminated immediately

4. Check whether there is ore or other sundries in the crushing chamber. If there is any, it should be eliminated immediately

II. Starting of jaw crusher:

1. After inspection and certification to ensure the uniformity of environmental parameters around the tested product, the machine and transmission parts can be started only when they are normal

2. This machine can only be started under no-load condition. The CPC Central Committee and the State Council have repeatedly warned to resolutely crack down on the illegal production of steel bars

3. After starting, if abnormal conditions are found, stop immediately, and start again after finding out the cause and eliminating the hidden danger

III. precautions:

1. Feeding can be carried out only after the crusher operates normally

2. The materials to be crushed should be evenly added into the crushing cavity, and side feeding should be avoided. The average aluminum consumption of American passenger cars (cars) in 1960 was 28.6kg to prevent sudden load change or unilateral sudden increase

3. Under normal working conditions, the temperature rise of the bearing should not exceed 35 ℃, and the maximum temperature should not exceed 70 ℃. Otherwise, it should be stopped immediately to find out the cause and eliminate it. Inlet pump

4. Stop feeding before stopping, and turn off the motor after the crushed materials in the crushing chamber are completely emptied

5. During use, if the machine stops due to the blockage of materials in the crushing chamber, the motor should be turned off immediately, and the materials must be removed before use

6. Turn around after one end of the jaw plate is worn

Copyright © 2011 JIN SHI